We investigated the effect of MAPP content on the mechanical prop

We investigated the effect of MAPP content on the mechanical properties of the composite, which were drastically improved by MAPP addition. Needle-leaf unbleached kraft pulp (NUKP)-derived MFC composites had better mechanical properties than needle-leaf bleached kraft pulp (NBKP)-derived MFC composites. Injection molded NUKP-derived MFC composites NVP-AUY922 research buy had good mechanical and thermal properties. The tensile modulus of 50 wt% MFC composite was two times, and the tensile strength 1.5 times higher than that of neat PP. The heat distortion temperature of 50 wt% MFC content composite under 1.82 MPa flexural load was increased by 53 A degrees C, from 69

to 122 A degrees C. This newly developed

continuous process using powder resin has the potential for application at an industrial level.”
“Introduction.-Sagittal pelvic balance is a recognized factor influencing targeted acetabular-component anteversion find more during total hip arthroplasty implantation. However, no studies in the literature have systematically reported pelvic parameters data in the standing, sitting and supine positions.\n\nHypothesis.-Variations in acetabular cup orientation can be traced to eventual pelvic balance changes in one of these three usual positions.\n\nMaterials and methods.-In these three positions (supine, standing and sitting), pelvic anatomical parameters and reference planes were radiologically defined from a group of 67 patients (average age: 70.2 +/- 3.2 years). The complete X-rays individual JIB-04 in vivo sets were digitized and measurements were obtained by a single operator using a Spineview software (previously, strictly validated for these kind of measurements). Positioning according

to the Lewinnek pelvic coordinate system, which is considered as a possible source of errors when vertically standing or horizontally lying, was also investigated.\n\nResults.-The average pelvic incidence of 59.6 degrees did not vary in the sitting, supine or standing positions, with no statistically significant difference between sexes. The Legaye equation-pelvic incidence is equals to pelvic version plus sacral slope-was verified. Pelvic version increased by an average 22 degrees from the sitting to the supine or standing positions. Sacral slope varied in a reverse order. Pelvic-femoral angle (PFA) decreased by 20 degrees from the standing to the supine position. The Lewinnek plane was located 4 degrees posterior to the vertical plane. Whatever the position adopted, pelvi-Lewinnek angle appeared constant, averaging 12 degrees.\n\nDiscussion.-The average pelvic incidence in this series was high, most probably associated with advancing patient age and/or pathology. The concept of functional anteversion sitting, supine or standing) positions.

Comments are closed.