As expected, the as-prepared CdS-TiO2 composite exhibited high activity and strong durability for the photodegradation

of Selleck Talazoparib methyl orange (MO) under simulated solar irradiation. Methods Synthesis of CdS-TiO2 NWs photocatalysts All chemicals are of analytical grade and used as received. In a typical synthesis, Ti foils are cut into 15 mm × 10-mm sizes and ultrasonically cleaned in acetone, alcohol, and distilled water for 5 min, respectively. After polishing in a mixed solution of HF, HNO3, and distilled water (the volume ratio was 1:1:4) for three times, 30 mL of 1 M NaOH aqueous solution and the polished Ti foils were transferred into a 50-mL Teflon-lined autoclave, which were kept at 200°C for 48 h before cooling to room temperature naturally. The obtained foils containing TiO2 NWs were rinsed thoroughly with distilled water and then annealed at 350°C for 3 h in air atmosphere. CdS QDs were fabricated onto the TiO2 NWs by CBD approach. TiO2 GDC0449 NWs were sequentially immersed in two different beakers for 5 min at every turn. The first one contained 0.1 M Cd(NO3)2, and the other one contained 0.1 M Na2S in DI water. Following each immersion, the films were dried at 100°C for 30 min before the next dipping. This was called one CBD cycle. In order to make sure that the CdS QDs were uniformly deposited on the TiO2 NWs, the

cycles were repeated two times, four times, and six times. The samples labeled as CdS(2)-TiO2 NWs, CdS(4)-TiO2 NWs, CdS(6)-TiO2, and CdS(10)-TiO2 NWs correspond to two, four, six, and ten CBD cycles. Characterization The structures and morphologies of the as-obtained samples were characterized by X-ray powder diffraction (XRD; Bruker D8-ADVANCE,

Ettlingen, Germany) using an 18-kW advanced X-ray diffractometer with Cu Kα radiation (λ = 1.54056 Å), scanning electron microscopy (SEM; S4800, Hitachi, Y-27632 2HCl Tokyo, Japan), and high-resolution transmission electron microscopy (HRTEM; JEOL-2010, Tokyo, Japan). The ultraviolet-visible (UV-vis) spectrum was measured using a U-4100 Hitachi ultraviolet-visible near-infrared spectrophotometer in the range of 240 to 800 nm. Photocatalytic experimental details The photocatalytic degradation experiments for MO were carried out in a self-prepared open air reactor. During the degradation procedure, the samples were stirred in a 50-mL beaker containing 40 mL of MO aqueous solution (20 mg/L) with no oxygen bubbles. Before irradiation by a 350-W xenon lamp, the adsorption equilibrium of the dye molecules on the catalyst surface was established by stirring in the dark for 30 min, and the vertical distance between the solution level and the horizontal plane of the lamp was fixed at 10 cm. At an interval of 10 min, 3 mL of solution was taken out from the reactor. The absorbance of the solution was determined on a UV-vis BI2536 absorption photometer (UV-3200S, MAPADA Analytic Apparatus Ltd. Inc.