Arrais et al. [39] reported that extending the etching time for 35% phosphoric acid from 15 s to 45 s duration improved the bond strength of Single Bond (3M ESPE) to caries-affected dentin. However, its bond strength was still lower than that of normal dentin. Since a longer etching time would deepen the zone of demineralized

intertubular dentin, the discrepancy between the demineralized layer and resin monomer penetration could not be eliminated. Recently, the application of chemical cross-linker in the bonding procedures has been introduced, which may potentially increase dentin collagen stability due to a higher number of collagen cross-linkages [41]. When etch and rinse systems (One-step Plus, Bisco; Single Bond Plus, 3M ESPE) were used, application with the chemical cross-linking agents (glutaraldehyde and grape seed extract) Everolimus price for 1 h after acid etching significantly improved

bond strength www.selleckchem.com/products/PLX-4032.html to caries-affected and sound dentin, in which the cross-linked dentin matrix might mechanically strengthen incomplete resin-infiltrated demineralized zone at the bottom of the hybrid layer [41]. Self-etch systems have also exhibited lower bond strengths to caries-affected dentin than normal dentin, and their hybrid layers in caries-affected dentin are also thicker than those of normal dentin but absolutely thinner than those of etch and rinse systems [2], [6], [10] and [40]. Using self-etch adhesives, it has been generally accepted that there are fewer discrepancies between depths of demineralized zone and resin monomer penetration, because demineralization and resin monomer penetration occur simultaneously. However, TEM observation revealed a porous zone beneath the hybrid layer of self-etch

system in caries-affected dentin [6]. Nakajima et al. [9] reported that there was a thicker nitrogen-rich layer at the caries-affected dentin interface of 2-step self-etch system using EPMA analysis, which is indicative of a collagen-rich phase (Fig. 6). Light microscopy evaluation with Masson’s trichrome stain indicated Chlormezanone wider regions of non-encapsulated collagen in the caries-affected dentin interface of 1-step and 2-step self-etch systems [40]. These results indicate that self-etch adhesives could not fully infiltrate adhesive monomers into the demineralized zone in caries-affected dentin. Self-etch system cannot dissolve and remove acid-resistant mineral deposits in dentinal tubules of caries-affected dentin because of their higher pH. Therefore, an etch and rinse adhesive system using 30–35% phosphoric acid with stronger acidity might have the upper hand compared with self-etch systems, although phosphoric acid etching could not completely dissolve the mineral deposits in dentinal tubules in caries-affected dentin.